基于ADAMS与HyperWorks的某车型扭力梁强度分析及结构参数优选
黄巨成，高龙*，邹红军，汪翰明
（奇瑞商用车（安徽）有限公司，安徽 芜湖 241000）
摘要：针对某车型的扭力梁开发需求，首先基于该车型的硬点、整车及系统参数，利用ADAMS软件建立整车动力学模型，分析不同工况下的扭力梁受力点的受力情况，并提取各受力点力值。然后将各受力点的力值添加到按照实际工况进行约束的扭力梁的有限元模型中，分析各工况下的扭力梁强度，并根据强度分析情况对扭力梁结构参数进行优选，以满足各工况受力需求。分析结果及耐久路试结果表明，优化后的扭力梁满足各工况使用需求。
关键词：扭力梁；ADAMS；强度分析
中图分类号：U463.33 文献标志码：A doi：10.3969/j.issn.1006-0316.2018.12.009
文章编号：1006－0316 (2018) 12－0029－04
Strength Analysis and Structural Parameters Optimization of Torsion Beam of a Vehicle Based on ADAMS and HyperWorks
HUANG Jucheng，GAO Long，ZOU Hongjun，WANG Hanming
( Chery Commercial Vehicle (Anhui) Co., Ltd., Wuhu 241000, China )
Abstract：In this paper, according to the demand of torsion beam development of a certain type of vehicle, firstly based on the hard point, vehicle and system parameters of the model, the dynamic model of the vehicle is established using ADAMS software, and the stress of the torsion beam under different working conditions is analyzed. And extract the value of each stress point. Then, the force values of each stress point are added to the finite element model of the torsion beam constrained according to the actual working conditions, and the strength of the torsion beam under each working condition is analyzed, and the torsion beam is optimized and strengthened according to the strength analysis to meet the requirements. Demand for various conditions. The analysis results and endurance road test results show that the optimized torsion beam satisfies the requirements for various operating conditions.
Key words：torsion beam；ADAMS；strength analysis
———————————————
收稿日期：2018－06－04
作者简介：黄巨成（1981－），男，山东菏泽人，硕士，高级工程师，主要从事底盘设计开发研究方面的工作。*通讯作者：高龙（1986－），男，安徽太和人，硕士，工程师，主要从事底盘设计开发研究方面的工作。
设为首页 | 加入收藏 | 免责条款
《机械》杂志版权所有 Copyright©2008-2012 Jixiezazhi.com All Rights Reserved
电话：028-85925070 传真：028-85925073 E-mail：jixie@vip.163.com
地址：四川省成都锦江工业开发区墨香路48号 邮编：610063
Powered by PageAdmin CMS